FEYNLAB® A50 SUPER HEAVY CUTTING COMPOUND

PRODUCT DESCRIPTION
FEYNLAB® A50 SUPER HEAVY CUTTING COMPOUND is the most sophisticated cutting compound in the automotive paint & refinish markets.

FEYNLAB® A50 SUPER HEAVY CUTTING COMPOUND contains the most advanced ceramic aluminum-oxide technology. These abrasives are incredibly hard and microscopically sharp compared to the competition. This means more cut, less diminishing of abrasives, and less product used compared to the competition.

FEYNLAB® A50 SUPER HEAVY CUTTING COMPOUND was specifically developed to compound and remove swirls and even deeper scratches from clear coated automotive painted surfaces, while leaving a superior clarity on the surface.

PRODUCT BENEFITS
Effortless removal of even the deepest surface imperfections, including 1000 grit sand marks
Perfect for heavily scratched painted automotive finishes prior to FEYNLAB® coating
Fast and consistent cut
Cost saving as less product is needed when compared against the
Simple & quick wipe off

APPROVED SURFACES
APPROVED SURFACES FOR APPLICATION ONLY – DO NOT apply to unapproved surfaces*
Clear Coated Painted Surfaces
Single stage paint surfaces
Gel-coated surfaces
*The use of Feynlab products on any surface not explicitly listed in the instructions booklet is done at the user's own risk. If damage occurs to the surface as a result of using the product on an unlisted surface, we will not be held liable for any such damage.

INCLUDED
1 kg or 5 kg of FEYNLAB® A50 SUPER HEAVY CUTTING COMPOUND

CAUTIONS
We encourage the use of gloves, an approved face mask and eye protection when using any compounds or polishes.

PREPPING THE SURFACE
Place vehicle in a well-lit, cool, & contamination free environment
Remove all excessive surface dirt and contaminants using either PURE WASH or PURE RINSELESS
Clay the surface to remove any surface bonded contaminants

ROTARY POLISHER DIRECTIONS
Shake the bottle vigorously for 1 minute before use. Regularly, give the bottle a few shakes during each compounding
Prepare the wool pad by placing 4 dime size dots and spread around on the face of the pad. Then place 4 dime size dots on the face of the pad and spread around area to be
In general, begin with a 2 x 2-foot section. Decrease working area if heavier correction is
Using a speed of no more than 1600 rpm, make 2 – 4 slow passes over the given
Wipe clear with a clean microfiber
Check your results from multiple angles to ensure complete removal of
Although A50 can be used as a final polish, Feynlab highly recommends a final polish with a DA Polisher to remove and rotary trails that may be left behind.
Admire your Take lots of pictures. Brag about it to your friends and give the FEYNLAB® team a virtual high five.

DUAL-ACTION (DA) POLISHER DIRECTIONS
Shake the bottle vigorously for 1 minute before use. Regularly, give the bottle a few shakes during each compounding
Prepare the microfiber or foam pad by placing 4 dime size dots and spread around on the face of the pad. Then place 4 dime size dots on the face of the pad and spread around area to be
In general, begin with a 2 x 2-foot section. Decrease working area if heavier correction is
Using a speed of 3400 – 4000 opm, make 2 – 4 slow passes over the given
Wipe clear with a clean microfiber
Check your results from multiple angles to ensure complete removal of
Admire your Take lots of pictures. Brag about it to your friends and give the FEYNLAB® team a virtual high five.

SHELF LIFE
2 years in a normal, climate-controlled environment.